Anyone know anything about mass airflow sensors?

[busabeast]

5 hours ago, Buckster said:

What are the load resistors for?

Resisting loads.... the clues in the name 

[Buckster]

2 hours ago, busabeast said:

Resisting loads.... the clues in the name 

You should put some in the busa seat.

[Nute]

I’m using LED indicators and the load from them is too small for the original relay which just goes into meltdown. The resistors in each indicator line allows the flasher relay to work properly. I initially forgot them . When I had wired it all up I tested the indicators and just got a high pitched squeal and nothing else, so had to redo those bits.
 

Will connect up the front ones tomorrow, I have sleeves which goes between the upper and lower fork bridges on each side which have the indicators built in. I was going to put them on each end of the handle bar, and may still do that as well but got the ones integrated into the sleeves used, and cheap so will go with it and see what I think once they are fitted. 
 

 

[KAYZ1]

you could always change the Resistors for an LED relay.. sold on many E sites and the Bay of E,s