All Activity

You haven’t had a tooth since 1974.

Happy new year to all. I went to bed at 10.30, watched tele till 2am till Mandi got in. She didn't want to go out either but was dragged out by the daughter.

I remember you saying this would happen. Wish I had the cash and room. Is storage not an option till you get yourself a place sorted.

Happy New Year Ren

Happy New Year Dear Boy. Hope it's a good one.

Or a wank

I havn't had a shit since 2025

You can fall over before you set off if I recall correctly.

Not a full blown drag bike no but I will be lengthening the swingarm, road legal shinko hook up drag radial,2step ignition, slave cylinder support bracket and heavy duty springs and new plates, I have the front strap and rear drop links That will keep it road legal but drag biased

Happy new year mate, enjoy your evenings all Happy new year to the whole forum

Yeah i sent my cg125 down the road 6 days after riding, then nothing till my big 1 at 6 months of riding, then my second bike i sent it down the road a few times so at his age I too was abit of a numpty on the bike. Hopefully he continues to treat shadow right and gets through the youth stage on bike

You never know, he is 19 and dumb as a rock but I can’t claim to have been much different at his age. To my knowledge he has been down 3 times in 2 years. He treats Shadow right and I genuinely like him so I hope he gets through. Shadow won’t let him hang with the numpties anymore so that is a positive. She bollocks him about bad riding

Thank you everyone, I will put the picture of my bike up shortly.

Had a nice dinner with Sofia, and now settling in from if the TV to see some Youtube Dakar broadcasts and drink a little whiskey. Happy New Year to all!

Congratulations @Saul, BOTY!

No but seriously are you planning to turn the busa into a full blown drag bike ? So your not riding it anymore..?

I just hope i can make to next year, at the Moment looks like the lad is about to through me out now his Mum has gone and the house will be his. anybody UK want milling machine Lathe band saw and Bench drill...the later has not drilled a hole yet...i will be buggered if i leave them for him i will cut them up or give them the scrap man first... No bull offer. PS: i would like 3grand for the lot but: Ow! just remembered..Also 500kl bike lift goes up vertically not in an arc..drybollic with small compressor for locks..

What about the beauty salon ?

That a 2v model Nute?

My plan for this year is a full season of rwyb at santa pod getting ready for bracket racing in 2027

Is he one of those who's tyres cant keep him upright? If so I think he should look at how he's riding before he runs out of his 9 lives, and hopefully long before he does something big

Earth connection was the first thing I looked at, injectors are new, loom is the original and the bike ran (briefly and like a tractor) before I pulled it apart. Continuity, where I can check it is fine. They are crank position sensors, two of them, at 0 and 180 degrees from memory when I pulled the cover off. Depending on how long I spend at the pub tonight I will have a look tomorrow and see what sense I can get from them as Ian suggests with a magnet. I assume I’m looking for a gradual change 0-12v across the signal and ground ( there are 3 wires) ?

Prolly not, his problem if he gets stopped. Shadow’s, is that’s all that concerns me.