Vamana Gupta Posted 4 hours ago Share Posted 4 hours ago 18 minutes ago, Buckster said: If you find the specs of the sensors you can make them easily enough. They are a very simple and readily available semiconductor device. You can test them with a multimeter, just power up the circuit then look for a fluctuation in voltage when you run a magnet near them. Let's start with the basic numbskull...before he starts waving around magnets on a magic wand ... Link to comment Share on other sites More sharing options...
Nute Posted 2 hours ago Author Share Posted 2 hours ago Earth connection was the first thing I looked at, injectors are new, loom is the original and the bike ran (briefly and like a tractor) before I pulled it apart. Continuity, where I can check it is fine. They are crank position sensors, two of them, at 0 and 180 degrees from memory when I pulled the cover off. Depending on how long I spend at the pub tonight I will have a look tomorrow and see what sense I can get from them as Ian suggests with a magnet. I assume I’m looking for a gradual change 0-12v across the signal and ground ( there are 3 wires) ? Link to comment Share on other sites More sharing options...
Catteeclan Posted 1 hour ago Share Posted 1 hour ago That a 2v model Nute? Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now